ENGINEGUARD CRASHBAR STEEL

[hl3013st]

Almost ready i have done some more holes and i painted. tomorow i will put it

[cgblueman]

  can't wait to see it. What have you painted it with?

[hl3013st]

the first photo is a layer to protect from oxidation:
(Sorry, but you are not allowed to access the gallery)
and then black paint :
(Sorry, but you are not allowed to access the gallery)

[scoot]

As I say RED is faster bud 
Scoot

[hl3013st]

 

[Inazuma55]

hl3013st

Thanks scoot, tomorow i will test it.

   you're going to drop your bike......on purpose

  nah...Good Work there hl 
I was wondering how well the welds on the bought Suzuki one would stand up - the weld of the two flats to the cylinder. Seems a vulnerable point to me where the welds could just snap off. I'm sure yours will be strong enough because you have control of the quality yourself.
 

[hl3013st]

Inazuma55

  you're going to drop your bike......on purpose

  nah...Good Work there hl 
I was wondering how well the welds on the bought Suzuki one would stand up - the weld of the two flats to the cylinder. Seems a vulnerable point to me where the welds could just snap off. I'm sure yours will be strong enough because you have control of the quality yourself.
 

May be i will drop down the inazuma on purpose to test it
I thing we did a good work and it seems better than the bar in the youtube video

[hl3013st]

upgrade complete:
(Sorry, but you are not allowed to access the gallery)
(Sorry, but you are not allowed to access the gallery)
(Sorry, but you are not allowed to access the gallery)
Tell me what you think

[cgblueman]

hl3013st

upgrade complete:
(Sorry, but you are not allowed to access the gallery)
(Sorry, but you are not allowed to access the gallery)
(Sorry, but you are not allowed to access the gallery)
Tell me what you think

Bravo bravo bravo it looks great. did it take much effort to fit it?

[hl3013st]

Thanks man. The truth is that it wasn't easy